Nano Care

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Praesent egestas erat quam, eu bibendum ligula ultrices accumsan. Fusce egestas sed est vel interdum. Maecenas pharetra lectus vel ante tempor, vitae consectetur sem porta. Aliquam lacinia purus turpis, a convallis velit volutpat mollis. Vivamus rutrum dui vitae lectus pellentesque, et dignissim justo ultricies. Pellentesque porttitor vulputate placerat. Sed consequat magna sit amet imperdiet placerat. Pellentesque accumsan ex vel semper interdum.
Characteristics

Mattress

  • Epoxy coated steel tube frame.
  • Complete with supports for accessories (IV pole, lifting pole, etc.)

Comfort

  • Two independent sections made of HPL.
  • Useful Surface 100%.
  • Sections adjustment accomplished by low tension electric motors, in compliance with standard rule EN 60601-1.

Handling

  • Patient handset with clear drawing and pictograms for an easy use.
  • Electrical height adjustment ranging from 62 cm to 92 cm by electric actuators.
  • Trendelemburg y antitrendelemburg (±16º) through electrical actuation system.
  • Ø125 mm castors con with central braking system and steer facility.
  • Four bumpers on each corner of the bed base.

Security

  • Steel side rails with sliding adjustment up to 7 different positions allow an easy access with a system to avoid accidental reduction. Head and footboards covered with transparent plastic sheets 6 mm thick.
  • Quick emergency release backrest dropping system in the event of electrical or battery back-up failure.
  • Nano cot is manufactured under the directive 2007/47/CEE.
Data sheet

TECHNICAL DATA:

  • Power supply: 110-230V 50-60 Hz
  • Máximum consumption: 3,15 A
  • Protection indicator: IPX4
  • Protection class: Class II

ELECTRIC FEATURES:

  • Overall dimensions incluiding side rails: 1575 x 890 x 1550 mm
  • Patient Surface: 1400 x 720 mm
  • Height adjustment: 620-920 mm
  • Backrest tilting: 42,5º
  • Tredelemburg/reverse tredelemburg: ± 16º/16º
Normative
  • All products manufactured by Medisa comply with the directive 2007/47/CEE concerning medical devices (Annex I y Annex VII).
  • All processes have been evaluated and certified by standard requirements UNE-EN ISO 9001:2008 about Quality Management System and the standard UNE-EN ISO 14001:2004 of Enviroment Management System.
  • Medisa products are compliant the following standards:
  • IEC 60601-1
  • IEC 60601-1-2
  • IEC 60601-2-52
  • Certified by Bureau Veritas.
  • CERTIFICATES Nº ES047196-1 / ES047195-1
  • Scope: design, manufacturing, marketing, technical assistance for hospital beds and chairs.
Downloads